Fireye 120V Chassis IR Amplifier

The ZB110 (ZB230) is a chassis/flame amplifier module complete with mounting screws and blank display module. The display module (BLV512 or BLL510), if required, must be ordered separately. Functions such as pre-purge time, recycling or non-recycling interlocks, high fire proving interlock, and trial for ignition timing of the pilot and main flame are determined by the programmer module. The BurnerLogix Z System can be used with ultra-violet, autocheck infrared, flame rod, self-check ultraviolet flame scanners or direct coupled by choosing the proper chassis/flame amplifier module. Wiring bases for the BurnerLogix Z control are available pre-wired with 4 foot lead wires color coded and marked for easy installation or with an integral terminal block capable of a accepting up to 2 X 14 AWG wires. The wiring base terminal block is available with knockouts for conduit or open ended for cabinet mounting. The pigtail wiring base is 4" X 5" (101.6mm x 127mm) and the terminal block wiring base is 4" X 7" (101.6mm x 177.8mm). Additional functions of the BurnerLogix Z System include: • A non-volatile memory allows the control to remember its history and present position even when power is interrupted. • A consistent flame signal read-out via display module or 4-20 mA output. • Read-out of main fuel operational hours and complete cycles via display module. • Modbus communications via RS485 multi-drop link. • Proof of fuel valve closure during off cycle. • Burn-in time of program parameters occurs after 8 hours of main valve on time. • A run/check switch allows the operator to stop the program sequence in any of four different positions (Purge, PTFI, MTFI or Auto). • Remote Display mounting with NEMA 4X/IP66 protection. • Remote Reset • Programmable communication baud rate allows for DCS compatibility. • Keypad selectable language readout. • Revert to pilot can increase burner turn down. • Additional terminals provided for applications requiring additional inputs and outputs.